Home  >  Products  >  AC SPDs

AC Surge Protective Device SPD Surge Protection Device for Power Supply Systems

Surge protective device SPD surge protection device is a protective device for limiting transient voltages by diverting or limiting surge current and is capable of repeating these functions as specified.

Surge protection is a cost-effective solution to prevent downtime, improve system and data reliability and elimination of equipment damage due to transients and surges for both power and signal lines. It is suitable for any facility or load (1000 volts and below). Typical SPD applications within industrial, commercial and residential include:

  • Power distribution, control cabinets, programmable logic controllers, electronic motor controllers, equipment monitoring, lighting circuits, metering, medical equipment, critical loads, back-up power, UPS, HVAC equipment
  • Communication circuits, telephone or facsimile lines, cable TV feeds, security systems, alarm signaling circuits, entertainment center or stereo equipment, kitchen or household appliances

Type 1: Permanently connected, intended for installation between the secondary of the service transformer and the line side of the service disconnect overcurrent device (service equipment). Their main purpose is to protect insulation levels of the electrical system against external surges caused by lightning or utility capacitor bank switching.

Type 2: Permanently connected, intended for installation on the load side of the service disconnect overcurrent device (service equipment), including brand panel locations. Their main purpose is to protect the sensitive electronics and microprocessor based loads against residual lightning energy, motor generated surges and other internally generated surge events.

Type 3: Point-of-utilization surge protective device (SPD) installed at a minimum conductor length of 10 meters (30 feet) from the electrical service panel to the point-of-utilization. Examples include cord connected, direct plug-in and receptacle type SPDs

Surge Protective Device SPD Surge Protection Device-type-1

Type 1 

Un = 275 Vac

Iimp (10/350μs) = 25 kA / 50 kA

surge-protector-type-1+2

Type 1+2

Un = 275 Vac

Iimp (10/350μs) = 12,5 kA / 25 kA / 50 kA

surge-protector-type-2

Type 2

Un = 75Vac / 120Vac / 275 Vac / 385Vac / 440vac …

Imax (8/20μs) = 20 kA / 40 kA

TLP10-230

U= 230 Vac

Uoc = 10 kV, In = 5 kA, Imax = 10 kA