SLP10GI Module Series

Home>>SLP10GI Module Series

Project Description

LED Lights Surge Protection Device –  SLP10GI Module Series


Description

LSP’s SLP10GI thermally protected Surge Protective Device is a self-protected device specially designed to be used in outdoor and commercial LED lighting fixtures for transient overvoltage protection.

It has been developed with LSP’s thermally protected varistor technology.

Its built-in thermal disconnect function provides additional protection to prevent catastrophic failure and fire hazard even under extreme circumstances of varistor end-of-life or sustaining overvoltage conditions.

The SLP10GI features a built-in LED indicator that notifies when replacement of the module is needed.

  Applications

  Features

• Outdoor and Commercial LED Lighting
• Roadway lighting
• Traffic lighting
• Digital signage
• Wall wash lighting
• Parking garage lighting
• Flood lighting
• Tunnel lighting
• Street lighting

LED Lights Surge Protection Device - Applications

• Build-in LED Indication, saves maintenance time by identifying replacement need
• Thermally Protected
• Suitable for use in luminaire with Class I or Class II insulation∗
• 10kA Maximum Discharge Current (Imax), 8/20μs
• High line-to-earth/ground resistance
• IP66: Dust-tight and water resistant
• Parallel or Series connected options
• IEC 61643-11/EN 61643-11 recognized∗

∗ See ‘Part Numbering System’ for exact details of voltages available for Class I and Class II
installations, and ‘Device Ratings and Specifications’ table for voltage specific approvals.

LED Lights Surge Protection Device-Absolute Maximum Ratings

CAUTION: Stresses above those listed in ‘Absolute Maximum Ratings’ may cause permanent damage to the device. This is a stress only rating and operation of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied.

Surge Protective Device for LED Light-SPDs-Ratings and Specifications
Glossary:
1. MCOV/UC: Maximum Continuous Operating Voltage – maximum r.m.s. the voltage that could be continuously applied to the SPD.
2. Maximum Discharge Current Imax (A): The maximum discharge current is a measure of the SPDs maximum capability; the single impulse of discharge current uses the 8/20μs
current waveform. All Devices pass maximum discharge current with possible, safe opening of thermal disconnect.
3. Nominal Discharge Current In (A): The nominal discharge current is a measure of the SPDs endurance capability; 15 impulses of discharge current uses the 8/20μs current waveform.
4. MLV: Measured limiting voltage; the highest value of residual voltage measurements during the application of impulses of 8/20μs nominal discharge current (In); an average voltage value of 15 impulses
5. Up: IEC 61643-11 Voltage protection level; the highest value of residual voltage measurements during the application of impulses of 8/20μs nominal discharge current (In); a rounding voltage value of the maximum measurement.

Surge Protective Device for LED Light-SPDs technical data
LED-Lights-SPDs Repetitive Surge Capability
LED-Lights-SPDs-Dimensions
LED-Lights-SPDs-intallation and Part Numbering System

back to top